WEIHONG NK200 - Origin Parameters

Specialized Concentrated Focused
「134」Parameter Overview
Name
Setting Range
Default
Effect Time
Reference
The action of spindle
after processing
0: Stop;
1: Back to fixed point;
2: Back to workpiece origin
0
Immediately
3.5
Prompt after
machining ends
0: No prompt;
1: Red light for 3 seconds;
2: always red light until custom has
keyboard
0
Immediately
3.5
The X axis coordinate
of the fixed point
-67108.864~67108.864 mm
0
Immediately
3.5
The Y axis coordinate
of the fixed point
-67108.864~67108.864 mm
0
Immediately
3.5
The Z axis coordinate
of the fixed point
-67108.864~67108.864 mm
-1
Immediately
3.5
G73G83retract
amount
0~9999.9 mm
0
Immediately
-
This parameter is used under both G73 command and G83 command with different meanings.
When G73 command is used, this parameter means the uplifting distance after each peck. When
G83 is executed, this parameter refers to the distance between the feed plane where the cutter
changes from G00 to Gxx and the previous peck depth. See Programming Manual for the details of
G73 and G83.
Pause Z offset
0~10000 mm
10
After reboot
-
Open auto lubrication
Yes: Valid; No: Invalid
No
Immediately
-
Interval of opening
lubrication
0~34560000 sec
18000
Immediately
-
Opening time of
lubrication pump
0~34560000 sec
5
Immediately
-
Cycle machining
interval
0~34560000 sec
0
Immediately
-
4. Axis parameter
X-axis pulse
equivalent
0.0001~999 mm/p
0.001
After reboot
3.2.2
Y-axis oulse
equivelant
0.001
After reboot
3.2.2
Z-axis oulse
equivelant
0.001
After reboot
3.2.2
X-axis workbench
workbench lower limit~67108.864
400
After reboot
3.3.3