Specialized Concentrated Focused
「86」Maintenance
Fig. 4-2 Update System List
4) Press “Enter” after selection and start software update. The updating process is shown as below.
Fig. 4-3 System Update Procedure
5) The new software interface will be switched to automatically after system update completed.
The following gives the method to enter software update interface after USB with .weihong file is inserted into
NK200 on the condition that the previous software can be normally opened.
Under Diagnose function section, press F7 to enter system info interface and then click F2 to enter software
update interface. For more details, see 3.15.4.
To Next Page
Loading...
