Weinmann MEDUMAT Standard2 - Page 202

202 EN MEDUMAT Standard
2
WM 68071 05/2021
9 Function check
• The function check is ready (see "9.2 Preparing for the
function check", page 200).
1. Disconnect the device from the line power.
When doing so, note: If the device is switched on with the line
power connected, the function check cannot be started.
The following notice appears on the device display:
2. Switch on the device (see "4.5 Switching the device on",
page 64).
3. Select the menu item Function check.