92 EN MEDUMAT Standard
2
WM 68071 05/2021
4 Preparation and operation
1. Briefly open and then close the valve of the oxygen cylinder in
order to blow away any particles of dust.
2. Connect a pressure reducer to the valve of the oxygen cylinder
with a knurled union nut and tighten it by hand.
3. If necessary: Connect a low-pressure hose to the outlet of the
pressure reducer using the union nut.
4. If necessary: Connect a low-pressure hose to the compressed
gas connection of the device.
Result The device is connected to the oxygen supply.
To Next Page
Loading...
