Installing the water supply
1.
Flush through the customer's water supply pipe (Z).
2.
Fit the sediment filter (X) and, if necessary, a water treatment system
(W).
3.
Fit a separate shut-off device (Y) for each appliance.
4.
If a backflow preventer (V) or double check valve (DCV) are required
(see connection diagram), fit the relevant device in the water supply
line.
5.
Connect the appliance as shown in the connection drawing.
6.
Flush through the sediment filter by operating the recoil hand shower.
7.
Once the water supply has been installed, close the shut-off device.
8.
Inform the user about the service intervals for the filters, and the water
treatment system if applicable.
6 Installation
Installation manual 61
To Next Page
Loading...
