The General tab appears.
2. Touch the Parameters tab.
3. Touch the RRa tab.
4. Specify settings.
Setting Action/Description
RRa averaging Select the default averaging option that provides the
desired visibility of subtle variations in RRa
measurements.
Freshness timeout Select the period of time the device should wait before
alarming while it attempts to obtain a valid RRa reading.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Specify advanced SpO2 settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Parameters tab.
3. Touch the SpO2 tab.
4. Specify settings.
Setting Action/Description
Default view Select a numeric view or a waveform view as the default
primary SpO2 display on the Home tab.
Default response Select the default speed of response to changes in SpO2
measurements.
Sweep speed default Select the default waveform sweep speed for the SpO2
display in the Home tab.
Allow low perfusion alarm Select to enable Masimo low perfusion alarm.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced tabs and return to the Home tab, touch Exit.
Specify advanced pulse rate settings
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
Directions for use Advanced settings 193
To Next Page
Loading...
