Welch Allyn Connex VSM 6000 series - Attach the Temperature Probe; Remove the Temperature Probe and Well

Attach the temperature probe
CAUTION The temperature module only operates with the probe well
properly in place.
1. Remove the cover of the temperature module by pressing the tab on the bottom and
sliding the cover to the right. The cover is located at the bottom-right of the monitor,
below the probe well.
2. Hold the temperature probe cable connector with the spring tab on the right and
insert it into the probe port of the temperature module.
3. Push it into place until it clicks.
4. Reattach the cover. Use the alignment tab and slide the cover to the left to click it
back into place.
Remove the temperature probe and well
Follow these steps to disconnect the probe cable and remove the probe well.
1.
Remove the cover of the temperature module by pressing the tab on the bottom and
sliding the cover to the right. The cover is located at the bottom-right of the monitor,
below the probe well.
34 Setup Welch Allyn Connex
®
Devices