Western Digital Ultrastar DC HC310 - Error Reporting; Table 242 SMART Error Codes

277
Western Digital Hard Disk Drive OEM Specification
11.51.8 Error Reporting
The following table shows the values returned in the Status and Error Registers when specific error conditions are
encountered by a device.
Error Condition
Status Register
Error Register
A SMART FUNCTION SET command was received by the device without
the required key being loaded into the Cylinder High and Cylinder Low
registers.
51h
04h
A SMART FUNCTION SET command was received by the device with a
subcommand value in the Features Register that is either invalid or not
supported by this device.
51h
04h
A SMART FUNCTION SET command subcommand other than SMART
ENABLE OPERATIONS was received by the device while the device
was in a “SMART disabled” state.
51h
04h
The device is unable to read its Attribute Values or Attribute Thresholds
data structure.
51h
10h or 40h
The device is unable to write to its Attribute Values data structure.
51h
10h
Table 242 SMART Error Codes