White W3300 - Bobbin Winding and Installation; Guide Thread Through Machine; Prepare for Bobbin Winding; Start Bobbin Winding

01/22/2008
3.
Guide the thread
through the
machine and the
bobb
winding guide as
marked with the dotted
line.
4. Guide the
thread through the small hole
in the side of
ft
bobbin
from the inside, Holding
the thread end, push t[
bobbin winder shaft to
right.
*
Match the
groove of the bobbin with the
spring
on the
shaft
o
Spring on the shaft
•
Groove in the
bobbin
5.
Holding the thread end, press the
START/STOP”
butto
Wind the thread a few times
around the bobbin and pre
the “START/STOP” button
again.
Trim the excess thread
from the
top
of the bobbin after
ft
machine
stops.
*
it is important
to
trim the thread close to the bobbin.
6.
Press the
“START/STOP” button. The machine will
ste
automatically when the bobbin is full. Press th
“START/STOP” button
to stop at
any time or when th
bobbin has
stopped
moving and the motor is still running.
o
“START/STOP” button
7. Push
the
bobbin shaft
to
the left. Remove the bobbin an
continue sewing.
8.
Set the bobbin into the
shuttle
as
shown on
page
15.
It’s
a good
idea
to
have several full bobbins oi
hand before start your project.