Windhager FireWIN - Service Level

42
2. Operation
5s
RESET
Fig. 119
Operator level
Service level
Information level
MES Module
1
Choose Back
5s
RESET
Fig. 120
Service level only for trained
service personnel
5sec
5s
RESET
Fig. 121
Parameters
Start-up
Actuator test
Settings
Choose Back
2.8.2 Service level
System parameters, start-up and the actuator test can be
displayed, performed and/or modified in the service level.
Information!
Changes on the Service level may be perfor-
med only by trained service personnel (direc-
tions for setting, see the FireWIN Installation
instructions)
The menu item or sub-menu item is exited by pressing the
Back button (Fig. 121) or after a delay of 45 seconds.
1 only displayed when an MESplus control is present and this has been adjusted by a trained service technician in the basic settings.