Windhager FireWIN - 3. Care, cleaning and maintenance; 3.1 Overview of intervals between cleaning (maintenance)

46
3. Care, cleaning and maintenance
Care, cleaning and
ash removal intervals
FireWIN Klassik FireWIN Premium FireWIN Exklusiv
Depending on pellet
consumption approx.
every 37 kg
Add pellets to reserve
supply container
-
–
Depending on pellet
consumption approx.
every 400 kg
Operate the heating
surface cleaning lever
Frequent use of the lever
increases efficiency (see section 3.4)
Empty the ash pan
(see section 3.5)
Operate the heating
surface cleaning lever
Frequent use of the lever
increases efficiency (see section 3.4)
Empty the ash pan
(see section 3.5)
–
Display
“Clean boiler and
burner.
Confirm cleaning.“
IN 590
or
“Emergency operation!
Clean boiler and bur-
ner. Confirm cleaning.“
FE 390
Operate the heating
surface cleaning lever
Frequent use of the lever
increases efficiency (see section 3.4)
Empty the ash pan
(see section 3.5)
Clean combustion cham-
ber and burner pot
Note: The burner only needs cleaning
after every 3–4 cleaning requests.
(see section 3.6)
Confirm boiler and
burner cleaning
(see section 2.8.1.1)
Operate the heating
surface cleaning lever
Frequent use of the lever
increases efficiency (see section 3.4)
Empty the ash pan
(see section 3.5)
Clean combustion cham-
ber and burner pot
Note: The burner only needs cleaning
after every 3–4 cleaning requests.
(see section 3.6)
Confirm boiler and
burner cleaning
(see section 2.8.1.1)
Check reserve supply con-
tainer FireWIN,
if necessary remove dust
Empty the ash pan
(see section 3.5)
Clean combustion cham-
ber and burner pot
Note: The burner only needs cleaning
after every 3–4 cleaning requests.
(see section 3.6)
Confirm boiler and
burner cleaning
(see section 2.8.1.1)
Check reserve supply con-
tainer FireWIN,
if necessary remove dust
3. Care, cleaning and maintenance
3.1 Overview of intervals between cleaning (maintenance)
The FireWIN is equipped with a cleaning and ash removal interval display. The “Clean boiler and burner” cleaning
request is displayed on the InfoWINplus and must be reset after cleaning/ash removal has finished – see section
2.8.1.1.
A clean boiler saves fuel and protects the environment. Therefore always clean your boiler as required when the
cleaning and ash removal request is displayed.
The cleaning and ash removal intervals may be reduced or extended depending on the pellets used (e.g. ash
proportion), the power consumed by the heating system (frequently switching on and off) and the boiler size of
the FireWIN (9 and 12 kW).
Annual maintenance is required in addition to cleaning. This is performed by Windhager Customer Service or the
customer service Partners and is a prerequisite of the guarantee limitations.