Winmate M101B - Page 48

47
Rugged Windows Tablet M101B/ M101BL User Guide
NOTE:
User can download the SDK from Winmate Download center website
>> M101B/BL/BT >> Development Kit or check the Driver CD which is
shipped with the tablet.
http://www.winmate.com/DownCenter/DownLoadCenter.asp?DownType=2207&Onl
yContent=
Virtual COM
User can also choose Virtual COM to transfer scanned data to the defined
COM port.
Disconnect
User can tap on the Disconnect button to stop the connection with Barcode
Reader.
*To recover the connection, please tap on the button again to re-connect with
Barcode Reader.
Setting the 1D/2D Barcode Scanner Symbologies
The barcode scanner is shipped with default settings shown below. If the default setting suits the
usage requirement, setting symbologies is not necessary.
Symbologies Default Settings:
Symbologies
Default setting
1D
UPC-A
Enable
UPC-E
Enable
EAN-8
Enable
EAN-13
Enable
UPC-E1
Disable
GS1 DataBar Omni-Directinal
Disable
GS1 DataBar Limited
Disable
GS1 DataBar Expanded
Disable
Code 39
Enable
Code 128
Enable
ISBT 128
Disable
GS1-128
Enable
Interleaved 2 of 5
Disable
Matrix 2 of 5
Disable
Standard 2 of 5
Disable
Codabar
Disable
Code 93
Disable
Code 11
Disable
MSI
Disable
Plessey
Disable
Telepen
Disable
Australian Post
Disable
BPO
Disable
Canada Post
Disable
Dutch Post
Disable
Japan Post
Disable
PostNet
Disable
Sweden Post
Disable
2D
Data Matrix
Enable
PDF 417
Enable
Micro PDF 417
Disable
Codablock A
Disable
Codablock F
Disable
Maxicode
Disable