Need help?Do you have a question about the Wittmann Tempro basic C 90 and is the answer not in the manual?
Provides essential safety instructions for device operation and handling.
Highlights critical safety notes and precautions for proper device operation.
Specifies environmental conditions and space requirements for device installation.
Instructions for safely connecting the device to the power supply.
Information on the safety temperature cutout and its reset procedure.
Details the correct procedure for connecting the cooling water supply.
Guidance on connecting the tool circuits, including hose diameter and length.
Information on mains connection, fused protection, and load specifications.
Procedure for powering on the device using the main switch.
Describes the leakage monitoring system and its fault signals.
Details the operating modes for Tempro basic and primus C 90.
Instructions on how to change setpoint and other values using the control panel.
Procedure for adjusting the primary set point value (SET1).
Procedure for adjusting the set point value for the cooling down function (SET2).
Procedure for adjusting the tolerance limits (TOL) for temperature monitoring.
Instructions for switching the temperature stabilizing circuit ON and OFF.
Lists and explains possible error messages and their corresponding LED indications.
Details the safety temperature limiter, its function, and potential tripping causes.
Details the configuration menu (Code 120) and its various settings.
Provides essential information regarding required maintenance intervals and procedures.
Provides a schedule for regular maintenance tasks based on operating hours.
Crucial safety precautions and steps before opening the device for repair.
Step-by-step guide for replacing the heater element, including safety notes.
Procedure for exchanging the pump on the Tempro basic C90 model.
How to set and understand the motor protection relay settings and error messages.
Identifies common reasons why the motor protection relay may trip.
How flow rate is determined and entered in the configuration menu.
General| Temperature Range | 20…95 °C |
|---|---|
| Heating Capacity | 1.5 kW |
| Weight | 71 kg |
| Accuracy | ± 0.5 °C |
| Protection Class | IP54 |
| Power Supply | 50 Hz |
| Pump capacity | 60 l/min |
To Next Page