Tempro basic C 90 & Tempro primus C 90
Page 11
BASIC & PRIMUS C90 V 3.0 english / 10.04.2012
3 Assembly Instructions
The assembly and commissioning may only be undertaken by persons authorized
for this purpose, in order to avoid damage to devices, equipment and persons.
These assembly instructions presume knowledge about the regulations for the
prevention of accidents, working conditions, as well as safety regulations and their
implementation.
These assembly instructions presume knowledge in the fields of electricity and
mechanics, that have been acquired based on their training, experience and
instruction.
Ensure that all persons working with and on the device have the necessary
skills. Observe the safety instructions for the operation of transport and lifting gear.
All assembly work must be carried out while the machine is not powered and not
pressurised.
Our trained fitters are happy to assist you with this work.
3.1 Transport and Preparation for Assembly
The device and the accessories are delivered on pallets. At transport temperatures
of 0°C or below, the device should be left for 1 hour in a heated room before
starting it to allow it to return to room temperature.
To protect the device during transport and assembly, it is wrapped in protective
foil. Remove all foil before commissioning the device.
To transport the device (packing unit) on site, use only suitable lifting and transport
gear (e.g. forklift truck, pallet truck, etc.).
All transport and lifting gear must be operated by suitably qualified
personnel.
To transport and lift the device, proceed as shown in the pictures below. Secure
the device (packing unit) against toppling over/slipping from the forklift truck.
The transport of the device on rollers is only permitted for short distances on site.
To Next Page
Loading...