Wizard CMC Z1 - Hook up the Computer; Hook up Computer and Peripherals

Hook up the Computer
Hook up Computer and Peripherals
1. Place the computer on the computer stand.1. Place the computer on the computer stand.
2. Locate the Ferrite tube, which looks like a black doughnut and open 2. Locate the Ferrite tube, which looks like a black doughnut and open
it.. Wind the ECU power supply output cable around the inside of the it.. Wind the ECU power supply output cable around the inside of the
Ferrite three times, then close it shut.Ferrite three times, then close it shut.
3. Place the ECU and its power supply into the ECU bracket 3. Place the ECU and its power supply into the ECU bracket
on the back of the board.on the back of the board.
4. Locate one of the zip ties. Slip it through the plastic mount on the side of the ECU 4. Locate one of the zip ties. Slip it through the plastic mount on the side of the ECU
bracket and attach it to the Ferrite on the output cable of the power supply then bracket and attach it to the Ferrite on the output cable of the power supply then
secure it in place. secure it in place.
5. Hook up the keyboard and mouse by plugging their USB cables into the computer. 5. Hook up the keyboard and mouse by plugging their USB cables into the computer.
Some of the USB connections are in the back, and some are available along the side Some of the USB connections are in the back, and some are available along the side
of the computer. of the computer.
6. Plug in the computer power cord into the matching port on the computer, then 6. Plug in the computer power cord into the matching port on the computer, then
plug the power cord from the computer into a surge protector. plug the power cord from the computer into a surge protector.
20-36070-1 GettingStartedManualZ1FrameShop
04/07/21
13
Wizard CMC Model Z1 Hardware and Software Getting Started Manual
Wizard™ CMC Model Z1 Hardware and Software Getting Started Guide