Wizard CMC Z1 User Manual

6. After clicking Continue, the system will do another interference check. If a nger 6. After clicking Continue, the system will do another interference check. If a nger
clamp is still in the way, the screen will display which clamp number. Rotate the clamp is still in the way, the screen will display which clamp number. Rotate the
nger clamp out of the way and click Continue.nger clamp out of the way and click Continue.
7. For the next cutting job, the clamps should be rotated back toward the center of 7. For the next cutting job, the clamps should be rotated back toward the center of
the board. the board.
Mat Clamp Pressure
Setting the Mat Clamp Pressure
You can toggle the air pressure to the mat clamps between standard and low pressure with You can toggle the air pressure to the mat clamps between standard and low pressure with
the Mat Clamp Pressure Knob located on the control panel on the left side of the board. This the Mat Clamp Pressure Knob located on the control panel on the left side of the board. This
will allow you to cut delicate material such as foam core without crushing the material in the will allow you to cut delicate material such as foam core without crushing the material in the
clamps. The amount of pressure can be adjusted with the regulator knob mounted under the clamps. The amount of pressure can be adjusted with the regulator knob mounted under the
control panel.control panel.
Standard Clamp Pressure
Push the Clamp Pressure Knob in to use the standard clamp air pressure, which is suitable Push the Clamp Pressure Knob in to use the standard clamp air pressure, which is suitable
for most material. for most material.
Low Clamp Pressure
Pull the Clamp Pressure Knob out to use low clamp pressure, which is suitable for more Pull the Clamp Pressure Knob out to use low clamp pressure, which is suitable for more
delicate material, such as foam core. Lower pressure is applied to the mat clamps so that it delicate material, such as foam core. Lower pressure is applied to the mat clamps so that it
does not crush the material. When you have nished cutting the delicate material you can does not crush the material. When you have nished cutting the delicate material you can
push the knob in to reapply the standard air pressure to the clamps.push the knob in to reapply the standard air pressure to the clamps.
Adjusting the Clamp Pressure
Clamp Pressure Adjustment
To adjust the clamp pressure, see “Clamp Pressure Adjustment” page 15”To adjust the clamp pressure, see “Clamp Pressure Adjustment” page 15”..
20-36070-1 GettingStartedManualZ1FrameShop
04/07/21
25
Wizard CMC Model Z1 Hardware and Software Getting Started Manual
Wizard™ CMC Model Z1 Hardware and Software Getting Started Guide

Wizard CMC Z1 Specifications

General

Brand	Wizard
Model	CMC Z1
Category	Industrial Equipment
Language	English