Wizard CMC Z1 User Manual

12. The Head and Gantry will now automatically move to the left side of the board,
regardless of what position on the board they started.
13. The Head will move down until the foot block rests
against the Head Alignment Stop.
14. The foot block will align to the home position.
15. If you had clicked the Align the Head button, the CMC
is now aligned and ready to cut.
16. If you had clicked the Cut button, the CMC will now
prompt for the blade cartridge and blade depth.
Adjusting the Air Pressure for Denser Matboard
See “Adjusting Clamps for Zero Waste” on page 21 for more information.See “Adjusting Clamps for Zero Waste” on page 21 for more information.
Insert Blade Cartridge and Adjust Blade Depth
1. After 1. After Aligning the HeadAligning the Head, the user is prompted for the Blade Cartridge and , the user is prompted for the Blade Cartridge and
to conrm the blade depth.to conrm the blade depth.
2. If you are using the same blade cartridge as the last mat cut, you will not 2. If you are using the same blade cartridge as the last mat cut, you will not
need to change the cartridge. If it is di󰀨erent, change the current cartridge for need to change the cartridge. If it is di󰀨erent, change the current cartridge for
the requested cartridge.the requested cartridge.
3. The screen will also prompt you with the 3. The screen will also prompt you with the
Blade Depth that it will cut. If you wish to Blade Depth that it will cut. If you wish to
change the blade depth, click the minus change the blade depth, click the minus
(-) or plus (+) buttons on the cartridge change screen to select the desired (-) or plus (+) buttons on the cartridge change screen to select the desired
depth. When you click depth. When you click ContinueContinue, the hardware will automatically change , the hardware will automatically change
to that blade depth.to that blade depth.
4. The 45° blade cartridge and blade have already been inserted. The 4. The 45° blade cartridge and blade have already been inserted. The
blade depth prompt displays what depth it will cut at. Since we don’t need to make any changes, click blade depth prompt displays what depth it will cut at. Since we don’t need to make any changes, click
ContinueContinue..
5. The CMC will begin to cut. 5. The CMC will begin to cut.
After the CMC Has Cut the Mat
1. After the cut has nished, the head will return to the Home position, and the foot block will rotate to the 1. After the cut has nished, the head will return to the Home position, and the foot block will rotate to the
Aligned position for access to the blade cartridge. Unless the screen prompts to align the head, do Aligned position for access to the blade cartridge. Unless the screen prompts to align the head, do NOTNOT turn turn
the foot block.the foot block.
2. Remove the matboard from the CMC. The rst mat has been cut. 2. Remove the matboard from the CMC. The rst mat has been cut.
If The Cut Doesn’t Look Right
See See “Troubleshooting” on page 29“Troubleshooting” on page 29 for more information.for more information.
22
20-36070-1 GettingStartedManualZ1FrameShop
04/07/21
Wizard™ CMC Model Z1 Hardware and Software Getting Started Guide

Wizard CMC Z1 Specifications

General

Brand	Wizard
Model	CMC Z1
Category	Industrial Equipment
Language	English