Wizard CMC Z1 - Check Squareness

2. There are two shipping blocks on either side of the gantry 2. There are two shipping blocks on either side of the gantry
on the bottom rail. One is to the left side of the gantry on the on the bottom rail. One is to the left side of the gantry on the
underside of the bottom rail. The other is to the right of the underside of the bottom rail. The other is to the right of the
gantry on the top of the bottom rail.gantry on the top of the bottom rail.
3. Remove the two screws holding the gantry cover in place, and set the cover and 3. Remove the two screws holding the gantry cover in place, and set the cover and
screws aside.screws aside.
4. Remove the shipping blocks by loosening 4. Remove the shipping blocks by loosening
the 3/16” Allen screw from the T-Nut. Slide the 3/16” Allen screw from the T-Nut. Slide
the T-Nuts to the right end of the rail; a the T-Nuts to the right end of the rail; a
pencil tip helps. Reattach the T-Nuts to pencil tip helps. Reattach the T-Nuts to
the shipping blocks and place them in the the shipping blocks and place them in the
shipping box for storage.shipping box for storage.
Check Squareness
Check the Drive Belt Lines
1. Move the gantry all the way to the left. Move the gantry slowly 1. Move the gantry all the way to the left. Move the gantry slowly
toward the right until a red mark is visible on the drive belt of the toward the right until a red mark is visible on the drive belt of the
upper gantry. Conrm that the red mark lines up with the red mark upper gantry. Conrm that the red mark lines up with the red mark
on the toothed pulley.on the toothed pulley.
2. Without moving the gantry, look at the lower drive belt of the 2. Without moving the gantry, look at the lower drive belt of the
gantry and make sure the red mark lines up on the lower drive gantry and make sure the red mark lines up on the lower drive
belt and the toothed pulley. If they do not, call Wizard Technical belt and the toothed pulley. If they do not, call Wizard Technical
Support.Support.
20-36070-1 GettingStartedManualZ1FrameShop
04/07/21
9
Wizard CMC Model Z1 Hardware and Software Getting Started Manual
Wizard™ CMC Model Z1 Hardware and Software Getting Started Guide