Wizard CMC Z1 User Manual

Wizard CMC Model Z1 Hardware and
Software Getting Started Manual
Check Contents
Review equipment upon arrival for shipping damage. Contact Wizard if any damage is noticed. Verify that the
contents shown in the packing slip are received. Please save the packaging.
Equipment Required
The CMC Stand must be assembled rst before unpacking the Wizard™ CMC (Computerized Mat Cutter)
1/4” NPT female tting on main air line, or quick disconnect attachment
110 Volt Electrical outlet
Air source - You will need an air compressor that supplies between 100psi and 120psi.
Surge protector
Table for the computer/monitor
Where to Find More Information
Knowledge Base
The online help and Knowledge Base contains a wide assortment of searchable documentation and The online help and Knowledge Base contains a wide assortment of searchable documentation and
information. They can be found at:information. They can be found at:
• • FrameShop Software Online Help: FrameShop Software Online Help: https://wizardcutters.atlassian.net/wiki/spaces/FrameShop4x/
overview?homepageId=65929268. .
• • Z1 Hardware information can be found on the Knowledge Base: Z1 Hardware information can be found on the Knowledge Base: https://wizardcutters.atlassian.net/
wiki/spaces/KB/overview?homepageId=229492..
Website
Check out the Wizard website at Check out the Wizard website at www.wizardcutters.comwww.wizardcutters.com for additional information. for additional information.
20-36070-1 GettingStartedManualZ1FrameShop
04/07/21
5
Wizard CMC Model Z1 Hardware and Software Getting Started Manual
Wizard™ CMC Model Z1 Hardware and Software Getting Started Guide

Wizard CMC Z1 Specifications

General

Brand	Wizard
Model	CMC Z1
Category	Industrial Equipment
Language	English