EasyManuals Logo

Wizard CMC Z1 User Manual

Default Icon
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
For Low Setting: Turn the air regulator pressure knob counter-clockwise until the
marker on the gauge is at the low setting. Make sure the gauge does not go below
35 psi.
10. Set it by pushing the air regulator pressure knob back in.
11. Click OK to cut the mat with this setting.
Cutting an Extra Dense Layer with the 90° Cartridge
This setting is only for the 90° Cartridge and will not take a󰀨ect if another cartridge is selected. This setting will
allow the 90° Cartridge to cut at a slower pace.
1. Select the desired layer on the Cut Preview.
2. Click the Cut Speeds button to open the Cut Speeds Screen.
3. Click the checkbox for Extra Dense Material.
4. Adjust the slidebar to the desired percentage of cutting speed. For instance,
50% is 50% of the standard cutting speed for the 90° Cartridge.
5. Click OK. The Cut Preview displays the extra
dense layer with a pound sign and indicates that this layer is extra dense.
6. If needed, click on the Blade Depth button to open the Blade Depth
screen to adjust the Blade Depth to the
appropriate setting for this matboard
then click OK.
7. Click Cut to cut the mat and Align the
Head if requested.
8. A prompt to adjust the head pressure to the high setting displays.
9. Pull out the air regulator pressure
knob by pulling it to the left.
10. Turn the air regulator pressure knob
clockwise until the marker on the gauge is at the high setting. Make sure the gauge
does not go above 60 psi.
11. Set it by pushing the air regulator pressure knob back in.
12. Click OK to cut the mat with this setting.
90° Cartridge
See the Knowledge Base topic on 90° Cartridge and Blades at See the Knowledge Base topic on 90° Cartridge and Blades at https://wizardcutters.https://wizardcutters.
atlassian.net/wiki/spaces/FrameShop4x/pages/247267451/90+Degree+Blade+Cartridgeatlassian.net/wiki/spaces/FrameShop4x/pages/247267451/90+Degree+Blade+Cartridge to nd additional to nd additional
information on the 90° cartridge and changing the blades.information on the 90° cartridge and changing the blades.
20-36070-1 GettingStartedManualZ1FrameShop
04/07/21
27
Wizard CMC Model Z1 Hardware and Software Getting Started Manual
Wizard™ CMC Model Z1 Hardware and Software Getting Started Guide

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wizard CMC Z1 and is the answer not in the manual?

Wizard CMC Z1 Specifications

General IconGeneral
BrandWizard
ModelCMC Z1
CategoryIndustrial Equipment
LanguageEnglish