Wizard CMC Z1 - Page 4

To Next Page

To Previous Page

Mat Clamp Pressure Knob .....................................................................................15

Clamp Pressure Adjustment ..................................................................................15

Green Cut Button ....................................................................................................15

Turn the System On ......................................................................................................15

Power up the ECU ...................................................................................................15

Boot up the Computer ............................................................................................16

Design the First Mat .....................................................................................................16

Edit New Mat ............................................................................................................16

Go to Cut Preview to Cut the First Mat .......................................................................18

Align the Head When Motors are Disengaged ...........................................................21

Insert Blade Cartridge and Adjust Blade Depth ...................................................22

Design a Di󰀨erent Mat ..................................................................................................23

Select a Di󰀨erent Template ....................................................................................23

Adjusting Clamps for Zero Waste ............................................................................... 24

Mat Clamp Pressure .....................................................................................................25

Setting the Mat Clamp Pressure ............................................................................25

Adjusting the Clamp Pressure ...............................................................................25

Variable Pressure Optimization (VPO) Feature..........................................................26

Adjusting the Head Air Pressure for Regular or Dense Matboard .....................26

Cutting an Extra Dense Layer with the 90° Cartridge .......................................... 27

Changing the Blade ......................................................................................................28

Using the 45º Cartridge ..........................................................................................28

Using the Pen Cartridge .........................................................................................28

Blades and Cartridges ............................................................................................29

Aborting a Cut ...............................................................................................................29

Head LED Behavior ......................................................................................................29

LED Clamp Behavior ....................................................................................................30

Troubleshooting ...........................................................................................................31

Frequently Asked Questions ....................................................................................... 32

Hardware Maintenance ................................................................................................33

Maintenance Schedule ...........................................................................................33

Disclaimers ...................................................................................................................34

20-36070-1 GettingStartedManualZ1FrameShop

04/07/21

Wizard™ CMC Model Z1 Hardware and Software Getting Started Guide