Install the milk hose
The milk hose is already mounted on the All-in-One spout.
For refrigerated milk, use the brown milk nozzle (installed on delivery) •
For non-refrigerated milk, use the transparent milk nozzle from the accessories box •
The nozzle fits very tightly in the hose. The easiest way to remove it is to pull while twisting.
Move the All-in-One spout to the lowest position
>
Insert the milk hose into the guide >
The milk hose must not be under tension when in the lowest position, and must not run in front of the
grounds container.
Fill the water tank
Fill the water tank with cold tap water (max. 2.8 litres) >
Slowly slide the water tank back into the machine >
Fill the water tank only with fresh, cold water.
Never use hot water, mineral water, milk or other liquids.
Connect the milk hose to the milk
Place the refrigerated milk directly to the left of the machine >
Place the milk hose with the milk nozzle on it into the milk container >
The hose end with the milk nozzle should reach the bottom of the milk container.
Milk is a very sensitive food.
When handling milk, always ensure cleanliness.
Only open packs with clean hands and utensils.
Take care that no bacteria can be introduced into the milk.
To Next Page
Loading...
