Preparing milk and milk foam
At the touch of a button, the WMF 1000 also dispenses hot milk and milk foam.
press briefly press and hold
1 cup milk Milk foam on request
All-in-One spout in the top position All-in-One spout not all the way to the top
If a beverage is selected and the All-in-One spout is not in the appropriate position, then a reminder is
shown on the display. See WMF All-in-One spout, page 21.
Milk or milk foam can drip out a bit after dispensing. It is best to leave the cup under the
All-in-One spout briefly after dispensing, or to place a small catch basin under the spout.
Cup of warm milk
The All-in-One spout must be in the top position.
Place an appropriate drinking vessel under the All-in-One spout
>
Press the milk button 1x brieflyly >
Another press of the milk button ends dispensing prematurely.
After dispensing milk, the All-in-One spout should be slid downward slightly. The display prompts
for this.
Milk foam
The All-in-One spout must not be in the top position.
Place an appropriate drinking vessel under the All-in-One spout
>
Press and hold the milk button >
Milk foam is dispensed as long as the button is pressed.
- Cup of Milk: brown milk nozzle
- non-refrigerated milk: transparent
milk nozzle
w Settings w Cup size (Cup volumes)
Page 26
To Next Page
Loading...
