General care programs
The automtic coffee system rinse requires that sufficient water be in the tank at all times.
The rinse water (min. 120 ml) is caught in the drip tray. Empty the drip tray regularly or place a container
under the All-in-One spout during the rinse.
After each brewing cycle, in the heating up phase and during the care programs, so-called release water
runs into the drip tray. This rinses any remaining coffee from the pipes. This is a completely normal
procedure and not an error in the coffee machine.
Run the care program regularly, and without delay when the request to do so appears in the
display. WMF assumes no liability for damage due to lack of cleaning or descaling or due to
the use of other cleaning or descaling agents than those provided by WMF. All guarantee
and warranty claims are then void..
Cleaning and descaling agents are irritants and during execution of the programs, they
become very hot. Avoid any contact with these liquids. The plastic parts of the coffee
machine, with the exception of the water tank, must not come into contact with the
descaling agent.
Heed the instructions on the packaging and in the Safety chapter.
Call up the care programs
To select the care programs without a previous request on the display:
Briefly press the P button
>
Use the care button to browse to the desired program >
Select the displayed program with the P button >
select care program
browse: Care button
To Next Page
Loading...
