The coffee machine’s milk system is rinsed with hot water.
Hot rinse water is emptied through the All-in-One spout.
The display prompts:
Slide the All-in-One spout downward, out of the top position
>
The display indicates:
Turn the milk hose anticlockwise, disconnecting it from the hot water spout
>
After the rinse, some hot water remains in the milk hose. Hold the open end of the milk hose
over the drip tray so that the remaining rinse water can run out.
If beverages with milk were prepared, after 20 minutes or at the latest when switching
off, the machine automatically requests a milk system rinse. This results in steam being
dispensed briefly.
Confirm and perform the milk system rinse with the P button.
The All-in-One spout is cleaned by a pulse of steam at the same time.
The milk rinse can be delayed with the off/c button.
Cleaning the machine - Cleaning program
Perform the cleaning program weekly. The machine now heats up.
For further information on the cleaning interval, see page 39.
Do not drink the cleaning solution that comes out of the spout during cleaning.
Confirm machine cleaning with the P button
>
Follow the individual steps on the display >
lower spout into
beverage position
your selection pls
08:15 09.06.2008
Manual milk system cleaning
w Care w Manual cleaning
Page 44
Start the care program without request
w Care w General care programs
Page 36
The cleaning program takes 5 minutes.
machine cleaning
OK: P browse: Care btn.
To Next Page
Loading...
