EasyManua.ls Logo

WMF 1000 - Common Issue Troubleshooting

WMF 1000
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
59
Messages and instructions
Pump makes loud noises Water tank is not inserted correctly (air in the system).
Push in water tank completely
>
Bleed machine: >
Dispense hot water until a constant stream of water comes out
Instruction: It is normal if the water pump runs independently from time
to time during operation; it fills the system automatically.
Coffee has no crème • Unsuitable coffee mixture or coffee is not fresh
Quantity of ground coffee is set too low•
Cups too cold: pre-warm •
Brewing temperature too low: Increase temperature •
Grinding degree too coarse: Set grinding degree finer•
Carry out warm-up rinse•
Brewing unit can no longer
be pulled out or inserted
Brewing unit is not in the basic position
Close the right side door and switch machine on
>
The brewing unit can be adjusted using the multitool until the brewer >
can be inserted
Dirty brewing chamber Noticeably large amount and very coarse ground coffee in brewer area:
Reduce coffee strength or set grinding degree finer
>
Sludgy, mush-like coffee grounds:
Grinding degree is too fine, causing less grind in the brewer:
Increase coffee strength, or set grinding degree to more coarse
>
setting
Brewing temperature
w Settings
w Basic settings
w Settings w Grinding degree setting
Page 30

Table of Contents

Other manuals for WMF 1000

Related product manuals