Why do blades break prematurely on my Wood-mizer Saw?
Premature blade breakage on your Wood-mizer Saw can occur if the rubber belts on the blade wheels are worn to the point where the blade contacts the metal pulley. Look for shiny spots on the edges of the wheels and replace the blade wheel belts if necessary. Also, excessive blade tension can cause this; tension the blade to the recommended specifications.
How to stop sawdust buildup on the track of my Wood-mizer Saw?
Sawdust buildup on the track of your Wood-mizer Saw can be due to excessive lubrication; apply white lithium grease. Worn wipers may also cause this; adjust them for firmer contact or replace them. If the track is sticky, clean it and apply silicone spray.
General| Power | 14 HP |
|---|---|
| Fuel Type | Gasoline |
| Starting System | Electric Start |
| Max log diameter | 26 inches (66 cm) |
| Blade Length | 144 inches |
| Blade Width | 1.25 inches |
| Blade Thickness | 0.042 inches (1.07 mm) |
Covers safe practices for handling bandsaw blades, including warnings and precautions.
Outlines essential safety rules for operating the sawmill, including guards, hands, and clear paths.
Covers crucial safety guidelines for operating the gas engine, including ventilation and hot components.
General safety guidelines, including reading manuals, compliance with laws, and adult operation.
Comprehensive guide for installing the saw head onto the sawmill mast and carriage system.
Essential safety warnings and precautions before and during sawmill operation.
Guidelines for preparing the operating environment and the sawmill itself before use.
Detailed procedure for safely removing and installing new bandsaw blades.
Instructions on how to properly tension the bandsaw blade for optimal cutting.
Guidance on adjusting the blade's position on the wheels to ensure it runs true.
How to adjust the saw head position for parallel cuts and proper vertical alignment.
Safe procedures for starting the sawmill's engine or electric motor.
Step-by-step guide on how to safely load, turn, and clamp logs for sawing.
How to use the crank handle to adjust the saw head's vertical position.
Specific operating instructions and safety precautions for the G14 gas engine.
Comprehensive steps for performing normal sawing operations on a log.
Common problems, their causes, and solutions for operating the sawmill.
To Next Page
