TRANSMISSION
STW34, STW37, STW40, WSM
3-S14
2) Release Wire (Cruise Control)
1. Remove the left rear wheel and the fender cover.
2. Engage the cruise control lever (1).
3. Check the inner wire in the release wire (5) does not slacken.
4. Check the release lever (4) touches the cruise control lever (1)
by the spring (3), and the cruise control lever (1) touches the
stopper (2).
5. When not becoming like the above-mentioned, adjust with the
adjusting nut (6).
(Reference)
• If the inner wire is too tight, the cruise control lever (1) does not
touch the stopper (2).
9Y1211109TRS0012US0
3) Brake Link (Cruise Control)
1. Check the following operation of the brake link (2) by operating
the brake pedals.
2. The joint bolt (3) should move along the ditch and the lever (4)
must not rotate when one of brake pedals is pressed.
3. The joint bolt (3) must not move and the lever (4) should rotate
when right and left brake pedals are pressed at the same time.
4. If the operation is not normal, remove the brake link (2) and
check the damage and distortion of the link (2) and ditch (1).
• When reassembling the link, apply grease to the moving
portion.
9Y1211109TRS0013US0
(1) Cruise Control Lever
(2) Stopper
(3) Spring
(4) Release Lever
(5) Release Wire
(6) Adjusting Nut
Tightening torque Brake link retaining nut
7.8 to 9.3 N·m
0.8 to 0.95 kgf·m
5.8 to 6.9 lbf·ft
(1) Ditch
(2) Brake Link
(3) Joint Bolt
(4) Lever
To Next Page
