GENERAL
STW34, STW37, STW40, WSM
G-30
[5] CHECK POINTS OF EVERY 200 HOURS
Changing Engine Oil
• See page G-16.
9Y1211109GEG0024US0
Changing Engine Oil Filter
• See page G-17.
9Y1211109GEG0077US0
Changing Transmission Oil Filter
• See page G-18.
9Y1211109GEG0078US0
Checking Radiator Hose and Hose Clamp
Check to see if radiator hoses are properly fixed every
200 hours of operation or six months, whichever comes first.
1. If hose clamps (2) are loose or water leaks, tighten hose clamps
(2) securely.
2. Replace hoses (1) and tighten hose clamps (2) securely, if
radiator hoses (1) are swollen, hardened or cracked.
Replace hoses and hose clamps every 2 years or earlier if
checked and found that hoses are swollen, hardened or
cracked.
Precaution at Overheating
Take the following actions in the event the coolant temperature
be nearly or more than the boiling point, what is called
"Overheating".
1. Stop the machine operation in a safe place and keep the engine
unloaded idling.
2. Do not stop the engine suddenly, but stop it after about 5
minutes of unloaded idling.
3. Keep yourself well away from the machine for further 10
minutes or while the steam blown out.
4. Checking that there gets no danger such as burn, get rid of the
causes of overheating according to the manual, see
"TROUBLESHOOTING" section, and then start again the
engine.
9Y1211109GEG0025US0
Checking HST Oil Line and Power Steering Hose
1. Check to see that all lines (1), (2) and hose clamps are tight and
not damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
9Y1211109GEG0026US0
(1) Radiator Hose (2) Clamp
(1) HST Oil Line (2) Power Steering Hose
To Next Page
