wsm STW37 - Page 282

TRANSMISSION
STW34, STW37, STW40, WSM
3-S68
Clearance between Counter Shaft B and 27T Gear
1. Measure the counter shaft B O.D. with an outside micrometer.
2. Measure the 27T gear I.D. with an inside micrometer, and
calculate the clearance.
3. If the clearance exceeds the allowable limit, replace.
9Y1211109TRS0070US0
Clearance between Counter Shaft B and 32T Gear
1. Measure the counter shaft B O.D. with an outside micrometer.
2. Measure the 32T gear I.D. with an inside micrometer, and
calculate the clearance.
3. If the clearance exceeds the allowable limit, replace.
9Y1211109TRS0071US0
Clearance between 18T Gear Shaft and Bushing
1. Measure the 18T gear shaft O.D. with an outside micrometer.
2. Measure the bushing I.D. with an inside micrometer, and
calculate the clearance.
3. If the clearance exceeds the allowable limit, replace.
9Y1211109TRS0072US0
Clearance between
counter shaft B and 27T
gear
Factory specification
0.040 to 0.082 mm
0.00157 to 0.00323 in.
Allowable limit
0.1 mm
0.004 in.
Counter shaft B O.D. Factory specification
24.959 to 24.980 mm
0.98264 to 0.98346 in.
27T gear I.D. Factory specification
25.020 to 25.041 mm
0.98504 to 0.98587 in.
(1) 27T Gear (2) Counter Shaft B
Clearance between
counter shaft B and 32T
gear
Factory specification
0.040 to 0.082 mm
0.00157 to 0.00323 in.
Allowable limit
0.1 mm
0.004 in.
Counter shaft B O.D. Factory specification
28.459 to 28.480 mm
1.12043 to 1.12126 in.
32T gear I.D. Factory specification
28.520 to 28.541 mm
1.12283 to 1.12366 in.
(1) Counter Shaft B (2) 32T Gear
Clearance between 18T
gear shaft and bushing
Factory specification
0.000 to 0.062 mm
0.00000 to 0.00244 in.
Allowable limit
0.1 mm
0.004 in.
18T gear shaft O.D. Factory specification
17.989 to 18.000 mm
0.70823 to 0.70866 in.
Bushing I.D. Factory specification
18.000 to 18.051 mm
0.70866 to 0.71067 in.
(1) 18T Gear Shaft (2) Bushing
KiSC issued 11, 2014 A