EasyManua.ls Logo

wsm STW37 - Page 503

wsm STW37
555 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CABIN
STW34, STW37, STW40, WSM
10-S4
WINDSHIELD WIPER
9Y1211109CAS0001US0
Temperature Cannot
be Controlled (Mode
Motor and / or Mode
Switch Malfunction)
1. Mode motor is damaged Replace mode motor assembly. 10-S28
2. Mode switch is damaged Replace mode switch assembly. 10-S24
3. Wiring harness controller
is disconnected
Repair or replace wiring harness. –
Temperature Cannot
be Controlled
(Heater Hoses Laid is
Bad)
1. Heater hose is caught Repair heater hose. 10-S51
2. Heater hose is twisted or
bent
Repair or replace heater hose. 10-S51
Symptom
Probable Cause and
Checking Procedure
Solution
Reference
Page
Windshield Wiper
Does Not Operate
1. Fuse is blown
(Short-circuit, burnt
component inside motor or
other part for operation)
Correct cause and replace fuse. G-39
2. Wiper motor is damaged
(Broken armature, worn
motor brush or seized
motor shaft)
Replace wiper motor. 10-S31
3. Wiper switch is damaged Replace wiper switch. 10-S30
4. Foreign material interrupts
movement of link
mechanism
Repair linkage. –
5. Wiper arm is seized or
rusted
Lubricate or replace wiper arm. –
Windshield Wiper
Operating Speed Is
Too Low
1. Wiper motor is damaged
(Short-circuit of motor
armature, worn motor
brush or seized motor
shaft)
Replace wiper motor. 10-S31
2. Low battery voltage Recharge or replace battery. G-29
3. Humming occurs on motor
in arm operating cycle due
to be seized arm shaft
Lubricate or replace wiper motor. 10-S54
4. Wiper switch contact
improper
Replace wiper switch. 10-S30
Windshield Wiper
Does Not Stop
Correctly
1. Wiper motor is damaged
(Contaminated auto-return
contacts or improper
contact due to foreign
matter)
Replace wiper motor. 10-S54
Symptom
Probable Cause and
Checking Procedure
Solution
Reference
Page
KiSC issued 11, 2014 A

Table of Contents