wsm STW37 - Page 64

GENERAL
STW34, STW37, STW40, WSM
G-45
Injection Pump Pressure Tester
Application
• Use to check fuel tightness of injection pumps.
9Y1211109GEG0052US0
Bushing Replacing Tools
Application
• Use to press out and press fit the bushing.
1. For small end bushing
2. For idle gear bushing
9Y1211109GEG0053US0
A
Pressure gauge full scale: More than 29.4 MPa
(300 kgf/cm
2
, 4267 psi)
B Copper gasket
C Flange (Material: Steel)
D Hex. nut 27 mm (1.06 in.) across the plat
E Injection pipe
F PF 1/2
G 5 mm (0.20 in.)
H 17 mm dia. (0.67 in. dia.)
I 8 mm dia. (0.31 in. dia.)
J 1.0 mm (0.039 in.)
K 17 mm dia. (0.67 in. dia.)
L 6.10 to 6.20 mm dia. (0.2402 to 0.2441 in. dia.)
M 8 mm (0.31 in.)
N 4 mm (0.16 in.)
O 11.97 to11.99 mm dia. (0.4713 to 0.4721 in. dia.)
P PF 1/2
Q 23 mm (0.91 in.)
R 17 mm (0.67 in.)
S 4 mm (0.16 in.)
T 12.00 to 12.02 mm dia. (0.4724 to 0.4732 in. dia.)
U 100 mm (3.94 in.)
V M12 × P1.5
a Adhesive application
b Fillet welding on the enter circumference
A 162 mm (6.38 in.)
B 35 mm (1.38 in.)
C 27 mm (1.06 in.)
D 35 mm dia. (1.38 in. dia.)
E 27.90 to 27.95 mm dia. (1.098 to 1.100 in. dia.)
F 25.00 to 25.01 mm dia. (0.984 to 0.985 in. dia.)
A 175 mm (6.89 in.)
B 40 mm (1.57 in.)
C 38 mm (1.49 in.)
D 45 mm dia. (1.77 in. dia.)
E 41.90 to 41.95 mm dia. (1.650 to 1.652 in. dia.)
F 37.95 to 37.97 mm dia. (1.494 to 1.495 in. dia.)
KiSC issued 11, 2014 A