wsm STW37 - Page 68

GENERAL
STW34, STW37, STW40, WSM
G-49
NOTE
• The following special tools are not provided, so make them referring to the figure.
9Y1211109GEG0059US0
Adaptor for Flow Meter
Application
• Use for checking the hydraulic pump for 3P linkage.
NOTE
• When using, attach with following parts.
O-ring: 04811-00180
9Y1211109GEG0060US0
Hydraulic Arm Shaft Bushing Replacing Tool
Application
• Use for replacing the hydraulic arm shaft bushing in the
hydraulic cylinder block.
9Y1211109GEG0061US0
Piston Gasket Correcting Tool
Application
• Compress the power steering cylinder piston gasket to the
correct side when install the cylinder rod to the cylinder tube
with ease.
9Y1211109GEG0062US0
A 2-8.5 mm dia. (2-0.334 in. dia.)
B 40 mm (1.57 in.)
C 0.52 rad (30 °)
D 25 mm (0.98 in.)
E 15 mm (0.59 in.)
F 3 mm (0.118 in.)
G 1.7 to 1.9 mm (0.067 to 0.075 in.)
H 3.0 to 3.25 mm (0.118 to 0.128 in.)
I 8.0 mm dia. (0.315 in. dia.)
J 23.9 to 24.1 mm dia. (0.941 to 0.945 in. dia.)
K 60 mm dia. (2.36 in. dia.)
L PS 3/8
M 1.5 mm Round (0.059 in. Round)
N 0.3 mm Round (0.012 in. Round)
O Chamfer 0.2 mm (0.0078 in.)
Right Left
A
37.90 to 37.95 mm dia.
(1.492 to 1.494 in. dia.)
34.90 to 34.95 mm dia.
(1.374 to 1.376 in. dia.)
B 40 mm (1.575 in.) 35 mm (1.378 in.)
C 28 mm dia. (1.102 in. dia.) 25 mm dia. (0.984 in. dia.)
D 44.5 mm dia. (1.75 in. dia.)
E 30 mm dia. (1.18 in. dia.)
F 50 mm (1.97 in.)
G 10 mm (0.39 in.)
A 13.97 mm (0.55 in.)
B 35.052 mm (1.38 in.)
C 0.122 rad (7 °)
D 40.000 to 40.039 mm dia. (1.57 to 1.58 in. dia.)
E 46 mm dia. (1.82 in. dia.)
KiSC issued 11, 2014 A