Wulfsberg C-5000 User Manual

C-5000 COMMUNICATION MANAGEMENT CONTROLLER
INSTALLATION MANUAL
Publication No. 150-041118 Page 5-63
Rev. A Section 5 – Configuration and Programming
Sep 2001
Setting the Active Transceiver
You can toggle the active transceiver for a radio between Main and Guard by pressing the soft keys. The UPPER
SOFT key toggles the active transceiver for radio 1. The LOWER SOFT key toggles the active transceiver for radio
2. The following sequence of illustrations demonstrates this process for radio 1.
The Main transceiver is currently active.
11
123
→
→→
→
LUKEAFB TWR1
22
φ
φφ
φ
..1 TACTICAL-001
Pressing the UPPER SOFT key makes the digital transceiver (Guard) active.
11
.15
TACTICAL-015
22
φ
φφ
φ
..1 TACTICAL-001
Pressing the UPPER SOFT key again makes the Main transceiver active.
11
123
→
→→
→
LUKEAFB TWR1
22
φ
φφ
φ
..1 TACTICAL-001
Selecting Preset Channels
Selecting preset channels in Mode 2 is conceptually the same as in Mode 1. If an MTM Guard receiver is active, the
user can only select preset channels programmed for an ITM, and the main transceiver will only allow you to select
channels programmed for a main transceiver. A ramification of this is that you cannot select the manual channel
while the Guard receiver is active.

Wulfsberg C-5000 Specifications

General

Brand	Wulfsberg
Model	C-5000
Category	Controller
Language	English