Wulfsberg C-5000 User Manual

C-5000 COMMUNICATION MANAGEMENT CONTROLLER
INSTALLATION MANUAL
Page 4-50 Publication No. 150-041118
Section 4 – Electrical Installation Rev A
Sep 2001
(10) EXTERNAL CTCSS TONE IN (Pin 18)
Provision for modulating the transmitter with audio outside the normal audio frequency
range of 300 to 3000 Hz. Approximately 0.3 Vrms will give 5 kHz deviation.
(11) TRANSMITTER POWER SELECT (Pin 27)
When used with control units not providing transmitter power selector switches,
grounding this line at the mounting rack will provide 10 watts of RF output power. The
C-920 has this line grounded inside the control unit and will provide 10 watts when used.
(12) 14V SWITCHED (Pins 65 And 66)
Provision for switched 14 V power from the RT-7200/RT-9600. These pins will provide
14 Vdc. Exercise caution not to exceed a combined current drain of 500 mA from pins 65
and 66.
(13) PTT OUT (Pin 64)
May be used to key external accessories such as Tone Encoders. This pin is grounded
through the microphone PTT switch.

Wulfsberg C-5000 Specifications

General

Brand	Wulfsberg
Model	C-5000
Category	Controller
Language	English