Page | 74
push down on the 2-Way Divider. You will feel it push past the O-Ring. The tubing must be seated past the
O-ring within the 2-Way Divider. See Figure H37.
5.4 Install the Locking Clips on the Check Valve and the 2-Way Divider. See Figure H38.
5.5 Align the Under-Counter Bracket with the remaining two holes and secure it with the Nut and Washer
Removed earlier. Cut the Bolts to length if necessary. See Figure H40.
5.6 Tighten the Cord Grips to strain relief the tubes. See Figure H40.
5.7 Insulate the product tubing.
To Next Page
Loading...
