Installation
2–24 975-0402-01-01
This guide for use by qualified installers only
Installing Optional Accessories
Optional accessories are available for purchase at Xantrex.
Call Customer Service to order the accessories below:
• Remote Panel (Part number: 808-8040-00)
• Battery Temperature Sensor (Part number: 808-0232-01)
Mounting the Optional Remote Panel
To mount the remote panel:
1. Choose a location for the remote panel that is within
15 m (50 ft.) from the charger. Use only the four-
conductor communications cable (RJ-11) that came with
the remote panel.
2. Use the enclosed mounting template to predrill mounting
holes.
Take care that there is nothing behind the surface for you
to damage such as other cables or pipes.
3. Connect the RJ-11 connector to the remote panel and
route it to the charger. Be careful not to damage the
connector locking tab when routing the cable. You can
use some tape to protect the locking tab from catching on
something and breaking off when routing the cable.
4. Once the Truecharge™ 2 Battery Charger is mounted,
plug the other RJ-11 connector into the Remote port on
the rear panel of the Truecharge™ 2 Battery Charger.
TC2 Series BattChg Install Guide.book Page 24 Monday, June 30, 2008 3:18 PM
To Next Page
Loading...
Need help?
General
