Installation
2–26 975-0402-01-01
This guide for use by qualified installers only
Configuring the Truecharge™ 2 Battery
Charger
Once the charger is connected to a battery on bank 1 or to
AC, it is live and it may be configured. The indicator LEDs
on the onboard display will illuminate for a second (power on
test) before reporting charging and battery status information.
When the remote panel is connected, there will be a short
delay of about 1three seconds before reporting charging and
battery status information. The remote panel will use this
time to query the charger for the current operating conditions.
If AC was already applied, ensure that the charger is ON by
pressing
ON/STANDBY if necessary.
TC2 Series BattChg Install Guide.book Page 26 Monday, June 30, 2008 3:18 PM
To Next Page
Loading...
Need help?
General
