Safety
vi 975-0402-01-01
This guide for use by qualified installers only
4. To avoid a risk of fire and electric shock, make sure that
existing wiring is in good condition and that wire is not
undersized. Do not operate the Truecharge™ 2 Battery
Charger with damaged or substandard wiring.
5. The use of any attachments not recommended or sold by
Xantrex, may result in risk of fire, electric shock, or
injury to persons.
6. Do not operate the Truecharge™ 2 Battery Charger if it
has received a sharp blow, been dropped, has cracks or
openings in the enclosure (especially when the fuse cover
has been damaged and will not close), or otherwise
damaged in any other way. If the Truecharge™ 2 Battery
Charger is damaged, see the Warranty section.
7. Do not disassemble the Truecharge™ 2 Battery
Charger—there are hazardous voltages within. It contains
no user-serviceable parts. See Warranty for instructions
on obtaining service. Attempting to service the
Truecharge™ 2 Battery Charger yourself may result in a
risk of electrical shock or fire and will void your
warranty. Internal capacitors remain charged after all
power is disconnected.
8. To reduce the risk of electrical shock, disconnect both
AC and DC power from the Truecharge™ 2 Battery
Charger before attempting any maintenance or cleaning
or working on any circuits connected to the Truecharge™
2 Battery Charger. Turning off using the on/standby
button on the remote panel will not reduce this risk.
9. The Truecharge™ 2 Battery Charger must be provided
with equipment-grounding conductors connected to the
AC and input ground, and from chassis to the DC ground.
TC2 Series BattChg Install Guide.book Page vi Monday, June 30, 2008 3:18 PM
To Next Page
Loading...
Need help?
General
