I
OF
6
Media
Will
Not
Feed
Problem
Media will not move into the Media Transport.
Cause
Corrective
Action
Media Feed Clutch
is
not functioning correctly. Refer to the
E
-
Paper Path Jam RAP.
Upper Feed Roll stub shaft
is
slipping in the
Replace the Upper Media Feed Roll
(PL
8.1)
Drive
Shaft.
Make a mark across both shafts,
and make a copy. If the the mark no longer
lines up, the shaft
is
slipping
Obstruction in the Turnaround Baffle. Check the area for pieces of media or other
material that may cause the media to jam.
8/96
OF
Media
Will
Not
Feed
2-82
25101251
5
To Next Page
Loading...
Need help?
General