Continued)
teplacement
JOT€: Before installing a new fuser roll, clean
the surface with film remover.
JOTE: Ensure that the thermistor is clean.
JOTE:
When installing a new fuser roll, be
careful while installing the roll
through the side frame of the
xerographic module.
JOTE: Step
1
Cand
D:
When reinstalling the
(2)
screws, ensure that the head of the
screw fits into the hole in the Fuser
Roll.
JOTE: Ensure that the thermistor touches the
heat roll.
,
(Figure
3):
Reinstall
the
fuser roll.
!.
Reinstall the heat rod (REP
10.1).
I.
Perform the
fuser
roll initiation procedure
,
(Section
6,
General Procedures).
Figure
3.
Reinstall the Fuser Roll
REP
10.2
To Next Page
Loading...
