EEuurrooppeeaann UUnniioonn
RRaaddiioo EEqquuiippmmeenntt aanndd TTeelleeccoommmmuunniiccaattiioonnss TTeerrmmiinnaall EEqquuiippmmeenntt
DDiirreeccttiivvee
The Facsimile has been approved in accordance with the Council Decision 1999/5/EC for pan-
European single terminal connection to the public switched telephone network (PSTN). However, due
to differences between the individual PSTNs provided in different countries, the approval does not
give an unconditional assurance of successful operation on every PSTN network terminal point.
In the event of a problem you should contact your authorized local dealer.
This product has been tested to and is compliant with ES 203 021-1, -2, -3, a specification for
terminal equipment for use on analog-switched telephone networks in the European Economic Area.
This product provides a user-adjustable setting of the country code. The country code should be set
prior to connecting this product to the network. Refer to the customer documentation for the
procedure for setting the country code.
Note: Although this product can use either loop disconnect (pulse) or DTMF (tone) signaling,
we recommend that you set it to use DTMF signaling for more reliable and faster call setup.
Modification of this product, connection to external control software, or connection to an
external control apparatus not authorized by Xerox will invalidate its certification.
SSoouutthh AAffrriiccaa
This modem must be used in conjunction with an approved surge protection device.
NNeeww ZZeeaallaanndd
1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It
indicates no endorsement of the product by Telecom, it does not provide any sort of warranty,
and it does not imply that any Telepermitted product is compatible with all Telecom network
services. Above all, it provides no assurance that any item will work correctly in all respects with
another item of Telepermitted equipment of a different make or model.The equipment may not
be capable of correct operation at the higher data speeds designated. 33.6 kbps and 56 kbps
connections are likely to be restricted to lower bit rates when connected to some PSTN
implementations. Telecom will accept no responsibility for difficulties that arise in such
circumstances.
2. Immediately disconnect this equipment should it become physically damaged, then arrange for
its disposal or repair.
3. This modem shall not be used in any manner which could constitute a nuisance to other Telecom
customers.
4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There
is no guarantee that Telecom lines will always continue to support pulse dialing.
5. Use of pulse dialing, when this equipment is connected to the same line as other equipment, may
give rise to 'bell tinkle' or noise and cause a false answer condition. If you encounter such
problems, do not contact the Telecom Faults Service.
172
Xerox
®
B1022 Multifunction Printer
User Guide
Regulatory Information
To Next Page
Loading...
Need help?
General
Weight and Dimensions
