CCoonnffiigguurriinngg NNeettwwoorrkk SSeettttiinnggss
AAbboouutt TTCCPP//IIPP aanndd IIPP AAddddrreesssseess
Computers and printers primarily use TCP/IP protocols to communicate over an Ethernet network.
Generally, Macintosh computers use either TCP/IP or the Bonjour protocol to communicate with a
network printer. For Macintosh OS X systems, TCP/IP is preferred. Unlike TCP/IP, however, Bonjour
does not require printers or computers to have IP addresses.
With TCP/IP protocols, each printer and computer must have a unique IP address. Many networks,
cable, and DSL routers have a Dynamic Host Configuration Protocol (DHCP) server. A DHCP server
assigns an IP address automatically to every computer and printer on the network that is configured
to use DHCP.
If you use a cable or DSL router, for information on IP addressing, refer to the documentation for your
router.
EEnnaabblliinngg tthhee PPrriinntteerr ffoorr SSccaannnniinngg
If the printer is connected to a network, you can scan to any of the following locations:
• FTP
• SMB
• HTTP
• HTTPS
• SFTP
• An email address
• A shared folder on your computer
For details, refer to Xerox
®
CentreWare
®
Internet Services.
Note: If your printer is connected using the USB cable, you cannot scan to an email address or
a network location, such as a shared folder on your computer.
For details, refer to the System Administrator Guide at www.xerox.com/office/B1022_B1025docs.
PPoowweerr SSaavveerr MMooddee
Power Saver mode reduces power consumption when the printer is left idle for a specified period.
PPoowweerr SSaavveerr LLeevveellss
There are two levels of Power Saver mode:
• Power Saver Mode 1 Timer: After a specified period of inactivity, the touch screen dims, then the
printer operates at reduced power.
• Power Saver Mode 2 Timer: After a specified period of inactivity, the touch screen becomes dark,
then the printer enters Standby mode.
38
Xerox
®
B1022 Multifunction Printer
User Guide
Getting Started
To Next Page
Loading...
