Overview
Xerox
®
B205 Multifunction Printer
User Guide
189
Lock is exist The folder already exists in the
file location.
• The device cancels the job. Change the
settings for the job, then try the job again.
• If the problem persists, contact your System
Administrator.
Filename is too long The filename is too long and
file access has been denied.
• The device cancels the job. Change the
settings for the job, then try the job again.
• If the problem persists, contact your System
Administrator.
Scan file is exist A duplicate filename exists. • The device cancels the job. Change the
settings for the job, then try the job again.
• If the problem persists, contact your System
Administrator.
BOOTP problem Auto
IP Run
A BOOPT server error has
occurred.
• Input a new static IP address.
• If the problem persists, contact your System
Administrator.
BOOTP problem
802.1x
Network Error
There is an 802.1X
authentication
error
Ensure that the 802.1X EAP Type, Username and
Password, Authentication Switch and
Authentication Server for the Device are
compatible.
Upgrade Error Reset
Printer
There is a problem with the
firmware upgrade.
Install the correct firmware. For further
information, refer to Software Updates.
Message Meaning Suggested Solutions