2.8 <
System setup>
PostScript
This menu provides you with the Print PS Error menu item.
EPSON
This menu sets the EPSON emulation configuration.
Lines
This item allows you to set vertical spacing from 5 to
128 lines for the default paper size. The lines may
differ according to the paper size and printing
orientation.
Item Explanation
Print PS
Error
You can select whether or not your printer prints an
error list when a PS error occurs.
•Select On to print PS 3 emulation errors. If an error
occurs, the job stops processing, the error message
prints, and the printer flushes the job.
• If this menu is set to Off, the job is flushed without an
indication of the error.
Item Explanation
Font
You can select the standard font that will be used in
EPSON emulation.
Character
Set
This item allows you to select a character set of the
desired language.
Character
Tab.
This item selects the character set.
Pitch
You can determine the font size by setting the number
of characters that will print in one horizontal inch of
type.
Item Explanation
Values: 5 ~ 128 (1 unit)
Values: On, Off
Values: SANSERIF, ROMAN
Values: USA, FRANCE, GERMANY, UK,
DENMARK1, SWEDEN, ITALY, SPAIN1, JAPAN,
NORWAY, DENMARK2, SPAIN2, LATIN
Values: ITALIC, PC437US, PC850
Values: 10, 12, 17.14, 20
Network menu
(Phaser 3600/N, Phaser 3600/DN only)
This menu lets you configure the network interface installed in your
printer. You can reset the network interface and print a configuration
page.
LPI
You can set the number of lines printed in one vertical
inch.
Auto
Wrap
This item determines whether or not the printer
automatically performs line feed when the data
overflows the printable area of the print material.
Item Explanation
TCP/IP
This item allows you to manually set the TCP/IP
addresses or receive the addresses from the
network.
• DHCP: The DHCP server assigns the IP address
to you automatically.
• BOOTP: The BOOTP server assigns the IP
address to you automatically.
• Static: You can enter IP address, subnet mask,
and gateway manually.
EtherTalk
This item lets you select whether or not you use the
EtherTalk protocol.
• Off: You can disable the EtherTalk protocol.
• On: You can enable the EtherTalk protocol.
NetWare
This item lets you select the IPX frame type.
• Auto: You can set the frame type automatically.
• 802.2: Select this value to use the IEEE 802.2
frame type.
• 802.3: Select this value to use the IEEE 802.3
frame type.
• Ethernet II: Select this value to use the Ethernet 2
frame type.
• SNAP: Select this value to use the SNAP frame
type.
• Off: You can disable the NetWare protocol.
Item Explanation
Values: 6, 8
Values: Off, On
Values: DHCP, BOOTP, Static
Values: Off, On
Values: Auto, 802.2, 802.3, Ethernet II, SNAP, Off
To Next Page
Loading...
