Xerox Phaser 3600 - In the Paper Exit Area; In the Duplex Unit Area

9.4 < Troubleshooting>
In the paper exit area
1 Open and close the top cover. The jammed paper is automatically
ejected from the printer.
2 Gently pull the paper out of the output tray.
If you do not see the jammed paper or if there is any resistance
when you pull, stop and go to the next step.
3 Open the rear cover.
4 Loosen the jammed paper if it is caught in the feed rollers. Then
gently pull the paper straight out.
5 Close the rear cover.
6 Open and close the top cover. The Printer will resume printing.
In the duplex unit area
If the duplex unit is not inserted correctly, a paper jam may occur. Make
sure that the duplex unit is inserted correctly.
Duplex jam 0
1 Open the top cover and pull the duplex unit out of the printer.
2 Remove the jammed paper from the duplex unit.
3 Insert the duplex unit into the slot.
4 Close the top cover then the printer will resume printing.
1
duplex unit
1