2.7 <
System setup>
Emulation menu
Use the Emulation menu to configure printer language emulation.
Secure Print
• Release All: If this menu is configured to Off,
Release item in Secure Print menu launches
only one file which agrees with the user name
and the passcode for the file.
If this menu is configured to On, Release
item in Secure Print menu releases every file
that matches the user name and the
passcode.
The default is Off.
• Delete: You can delete all of the pages
regardless of the user name or the passcode.
Low Toner
• Stop: When the toner in the cartridge
becomes almost empty, the machine will not
resume printing until you install a new Xerox-
genuine print cartridge.
• Continue: Even though the toner in the
cartridge becomes almost empty, the
machine will continue the printing job.
Cm or inches
You can set the unit in the machine with your
preferences either in centimeters or inches.
This selection affects the following menus.
• Simplex Margin in Layout menu.
• Custom Size of Tray 1MPT Size in Paper
menu.
Clear Setting This menu item allows you to restore the
printer’s factory default settings.
Item Explanation
Emulation
Type
The printer language defines how the computer
communicates with the printer.
If you select Auto, your printer can change the
printer language automatically.
Setup
See the tables on page 2.7 to configure the printer
language.
Item Explanation
Values: Release All, Delete
Values: Stop, Continue
Values: cm, inches
Values: Auto, PCL, PostScript, EPSON, IBM
Values: PCL, PostScript, EPSON, IBM
PCL
This menu sets the PCL emulation configuration. You can set the font
type, symbol type, lines per page, and point size.
Hex Mode
When you set this menu on, the printer will print the
unprocessed hex data.
Item Explanation
Typeface
You can select the standard font to be used in PCL
emulation.
• PCL 1~PCL 7’s interval between letters is fixed, and
PCL 8~PCL 45’s interval is proportional to the font
type and point size. You can adjust the font size of
PCL 1~PCL 7 using the Pitch item, and
PCL 8~PCL 45 can do using Point Size item.
• PCL 46~PCL 54’s interval and point size are fixed.
Symbol
This item selects the symbol to be used in PCL
emulation. The symbol is the group of numbers,
marks, and special signs being used when printing
letters. The default is PC8.
Point Size
When you select one between PCL 8 and PCL 45 from
the Typeface menu, you can determine the font size
by setting the height of the characters in the font. The
default is 12.00.
Courier
This item lets you select the version of Courier font to
use.
Pitch
When you select a font between PCL 1 and PCL 7
from the Typeface menu, you can determine the font
size by setting the number of characters that will print
in one horizontal inch of type. The default value, 10 is
the best size.
Item Explanation
Values: Off, On
Values: PCL 1 ~ PCL 54
Values: ROMAN8 ~ PCYRIL
Values: 4.00 ~ 999.75 (0.25 unit)
Values: Regular, Dark
Values: 0.44 ~ 99.99 (0.01 unit)