Xerox Phaser 3600 - Custom Installation

Installing Printer Software in Windows
5
NOTE : If your printer is not already connected to the
computer, the following window will appear.
• After connecting the printer, click Next .
• If you don’t want to connect the printer at this time, click
Next , and No on the following screen. Then the installation
will start and a test page will not be printed at the end of the
installation.
• The installation window that appears in this User’s
Guide may differ depending on the printer and
interface in use.
5 After the installation is finished, a window asking you to
print a test page appears. If you choose to print a test
page, select the checkbox and click Next .
Otherwise, just click Next and skip to step 7.
6 If the test page prints out correctly, click Yes .
If not, click
No to reprint it.
7 Click Finish .
NOTE : After setup is complete, if your printer driver doesn’t
work properly, reinstall the printer driver. See "Reinstalling
Printer Software" on page 10.
Custom Installation
You can choose individual components to install.
1 Make sure that the printer is connected to your computer
and powered on.
2 Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run, and an installation
window appears.
If the installation window does not appear, click
Start and
then
Run . Type X:\Setup.exe , replacing “ X ” with the
letter which represents your drive and click
OK .
If you use Windows Vista, click
Start → All programs →
Accessories → Run , and type X:\Setup.exe .
If the AutoPlay window appears in Windows Vista, click
Run Setup.exe in Install or run program field, and
click
Continue in the User Account Control window.
3 Click Install Software .
4 Select Custom installation . Click Next .