To Next Page

To Previous Page

Basic Scanning

Phaser® 8510/8560MFP Multifunction Product

5-5

Scanning Originals at the Phaser 8560MFP Product

Select one of three destinations for images when scanning originals at the

Phaser 8560MFP product’s control panel: Public Folder, private folder, or user name.

Note: Printing can continue while you are scanning originals at the system.

Scanning to the Public Folder

To scan originals to the Public Folder at the control panel:

1. Press the Scan button, select

Scan To, and then press the OK button.

2. Select

Public Folder, and then press the OK button.

3. Change the scan options on the control panel, if desired.

4. Press the Start button. The image is stored in the Public Folder on the product’s hard

drive.

5. Return to your computer and retrieve the images using CentreWare IS.

See also:

Using CentreWare IS to Retrieve Images on page 5-9

Scanning Options on page 5-17

Scanning to a Private Folder

To scan originals to a private folder at the control panel:

1. Press the Scan button, select

Scan To, and then press the OK button.

2. Select

<private folder>.

Private folders are listed alphabetically below

Public Folder. If there are more than

10 entries, the names are placed in alphabetic subgroups.

3. Select the alphabetic subgroup for your private folder, and then press the OK button.

4. Select your private folder, and then press the OK button.

5. If prompted, enter your four-digit password, and then press the OK button.

6. Change the scan options on the control panel, if desired.

7. Press the Start button. The image is stored in a private folder on the product’s hard drive.

8. When you finish scanning, press the Clear All button. This prevents the next person who

uses the product from scanning files to or deleting files from that location.

9. Return to your computer and retrieve the images using CentreWare IS.

Xerox Phaser 8560MFP User Manual

Other manuals for Xerox Phaser 8560MFP