Calibrating the Scanner
Phaser® 8510/8560MFP Multifunction Product
5-37
Calibrating the Scanner at the Document Feeder
To calibrate the scanner at the document feeder:
1. Place the Scanner Calibration page in the document feeder, so that the top edge of the
page enters the feeder first. Adjust the paper guides to fit against the page.
Note: Make sure the Scanner Calibration page is aligned correctly and the paper guides
are adjusted to fit against the paper. If the page is misaligned, the calibration procedure
will fail.
2. On the control panel, select
Document Feeder Step, and then press the OK button to
scan the calibration page.
3. Wait for the scan to be completed, and then select one of the following options:
■ If the control panel indicates Success, press the OK button. The calibration
procedure is complete.
■ If the control panel indicates Failure, press the OK button, and then repeat Steps 1–3.
Note: For more information about calibrating the scanner, see the Knowledge Base at
w
ww.xerox.com/office/8510_8560support.
LTR/LGL
To Next Page
Loading...
